Canadian Electrical Industry News Week

 

July 16, 2018

Electrical EconomyThe value of permits issued by Canadian municipalities increased 4.7% to $8.2 billion in May. This followed a 4.7% drop in April, the only month this year where municipalities reported a total value below the $8.0 billion mark.

Residential sector: Multi-family dwellings reach record high 

In the residential sector, municipalities issued $5.5 billion worth of permits in May, up 7.7% from April. This was the second-highest value on record, following the $5.7 billion worth of permits issued in October 2016. Five provinces posted increases, with Ontario and British Columbia reporting the largest gains. 

The multi-family dwelling component reached a record high in May, with municipalities issuing $3.1 billion worth of building permits. The increase was the result of higher construction intentions in British Columbia, Ontario and Alberta.

The value of single-family dwelling permits also rose in May, up 6.2% from the previous month to $2.5 billion. This was the first increase following four consecutive monthly declines. Ontario led the seven provinces that registered increases. 

Municipalities approved the construction of 21,344 new dwellings in May, up 6.6% from April. The rise was mainly attributable to multi-family dwellings, up 7.4% to 15,983 new units. Single-family dwellings increased 4.3% to 5,361 new units.

Non-residential sector: Commercial buildings post the largest decrease 

The value of non-residential building permits declined 0.7% in May to $2.7 billion. Four provinces reported lower intentions, led by Alberta and Quebec.

In the commercial component, the value of building permits decreased 3.1% in May to $1.6 billion. Six provinces posted declines, with Quebec and Saskatchewan reporting the largest drops. 

The value of institutional permits was down 3.9% in May to $522 million. This was the lowest reported value since July 2015, and continues an overall general decrease that began in October 2017. The decline began following the issuance of multiple permits for educational structures via the Post-Secondary Institutions Strategic Investment Fund and the construction of two new hospitals. 

In contrast, the value of industrial permits increased 10.6% in May to $557 million. Seven provinces posted gains, led by Manitoba and New Brunswick.

Provinces and census metropolitan areas: Ontario and British Columbia register largest increases

The total value of building permits was up in five provinces in May, led by Ontario and British Columbia. Yukon also posted a notable gain. The value of building permits grew in 16 of 36 census metropolitan areas (CMAs), with the Toronto CMA reporting the largest increase (+$473 million).

The value of permits in Ontario rose 12.0% in May to $3.3 billion. Increases were reported in every component except industrial buildings. The value of building permits in the CMA of Toronto rose 37.9% to $1.7 billion, following three monthly declines. The gain was the result of higher construction intentions for residential dwellings. Toronto approved the construction of 3,562 multi-family dwelling units, the largest monthly total since August 2015.

British Columbia issued $1.5 billion worth of building permits in May (+18.4%). The increase was the result of higher construction intentions for multi-family dwellings in the CMA of Vancouver. 

Yukon reported a large increase in May (+$17 million). Municipalities issued $19 million worth of building permits, with over 90% of the value stemming from residential construction. The gain was mainly attributable to the issuance of multiple permits for a large apartment-condominium project. 

In contrast, Quebec posted an 11.4% decline in May to $1.6 billion. The decrease stemmed from lower construction intentions for multi-family dwellings and commercial buildings. The value of permits issued in the CMA of Montréal was down 20.1% in May, following a strong April where $1.1 billion worth of permits were issued.

Source: Statistics Canada, www150.statcan.gc.ca/n1/daily-quotidien/180710/dq180710a-eng.htm

Changing Scene

  • Prev
Joshua Remigio, 29, of Leamington, Ontario was electrocuted last week while working on the property ...
O’Neil Electric Supply is very pleased to announce the addition of Siemens Canada EM LP as ...
Fluke is celebrating its 70th anniversary by giving away a prize package valued at US$6,000. Prizes ...
This past summer, from July 1 to September 15, AD Rewards ran the Redeem for a Dream promotion.
  Rittal Systems Canada, the world’s largest and most trusted manufacturer of ...
Learn about the latest trends in structured cabling. Offered by Fluke Networks, this seminar will ...
  After a decade of creating affordable, energy-efficient LED Lighting exclusively for the ...
Effective January 1, 2019, Ramy Yousif assumes the position of Rexel Atlantic’s General ...
Standard’s Mississauga Sales office has moved to a new location and is now fully operational. ...
Heather and Elaine Gerrie, co-presidents of Gerrie Electric, are this year’s winners of the ...

Electrician Forum Brought to you by Schneider Electric

As industry experts you know the products you use everyday better than anyone and should have input on what information you receive about products and what could improve them.

Therefore, we want your insight on the biggest challenges or issues you face when installing loadcentres, breakers (CAFI, GFI's…) and other surge protection devices. We ask that you do not provide product specific details but rather your general issues and concerns or any questions that have come to mind while working with these product types. Provide us with your valued expert insight into the issues you have faced so manufacturers can better inform you about the installation and use of these products. Lets generate some discussion that will help guide the Industry.

Make your comments  HERE

 

Codes and Regulations Brought to You by the CSA Group

  • Prev
In this article: Section 58 — Passenger Ropeways and Similar Equipment. Rule 58-000 ...
  Unauthorized CSA Group certification marks have been found on wiring by Triumph Cable ...
In this article: Section 52 — Diagnostic imaging installations. The CE code is a ...
In this article: Section 46 — Emergency Power Supply, Unit Equipment, Exit Signs, and ...
  In this article: Section 44 — Theatre Installations. The CE Code is a ...
CSA has published C22.2 No. 60947-7-3, the harmonized standard for low-voltage switchgear and ...
  Electric welders. The CE Code is a comprehensive document. Sometimes it can seem ...
  In this article: Section 40 — Electric cranes and hoists. The CE Code is a ...

 

Cloud

There has been a lot of talk about cloud computing and Software-as-a-Service (SaaS) models these days but both are relatively new to the lighting industry. Let’s take a look at what they are as well as their roles in commercial lighting.

What is cloud computing?

Cloud computing is the on-demand delivery of compute power, database storage, and applications via the Internet with pay-as-you-go or subscription-based pricing. Cloud computing means that instead of all the computer hardware, software, and data that you are using sitting somewhere inside your company’s network, it’s provided and managed for you as a service by another company and you access it over the Internet. 

Read More



Tools for the Trade

  • Prev
  IDEAL Industries has introduced Combination Drill Taps to its tool lineup. Combining the ...
  Stripping and crimping device, 100 - 240 V input voltage, for insulated ferrules with a ...
Professional all-in-one cutter/stripper for coaxial and twisted pair cables     ...
  Klein Tools' Coax Explorrer 2 tests coaxial cable and maps up to 4 locations   ...
  Ideal Industries' T-14 wire stripper s are ideal for all professionals working within the ...
  The ATS850 conveyor eliminates all types of electro static discharge requirements. ...
  Lorik Tool & Automation has the experience and ability to manufacture a variety of ...
  Ideal Industries' 26 piece insulated Journeyman kit is ideal for new electricians or for ...
  Klein Tools Deluxe Fish Rod Set comes in 19 pieces that when assembled can fish wire and ...
  BendWorks Software was designed to help electrical contractors adopt this new process ...

Product News

  • Prev
  Raising the bar in lighting performance, operational efficiency and employee safety, ...
Despite automated solutions, switchgear manufacturing still involves a great deal of manual work ...
Conceived from Karice’s award-winning creations, Olah takes aesthetic inspiration from a ...
Standard has added to its LED tape offering: the line now includes a RGB LED tape option, RGB tape ...
Encoder specialist POSITAL has announced a new generation of analog rotary encoders for position ...
With FANUC's FIELD system, manufacturers can connect ALL of their automation equipment (not just ...
Magic Lite’s new LED parking garage light delivers a bright, uniform illumination for ...
With more work being completed outside of the traditional office setting, having the right tools on ...
  Eaton has announced expanded fixtures, controls and accessories for its Halo ...
  The HALO Home Internet Access Bridge (Bridge) enables you to control your HALO Home ...

 

Peers & Profiles

  • Prev
Allison Wood and Dominique Rivet are two apprentices who had a wealth of career options available ...
  In a recent sit-down Electrical Industry Canada was able to learn a little ...
David Johns is a unique and dedicated individual both at home and in the workplace. At home he is a ...
    Sean Freeman is a vibrant, enthusiastic and selfless individual who has taken his ...
  Automation companies are drivers of innovation, and have penetrated near every industry ...
Total Electrical Solutions was founded in 2013 by Jeremy Herrington in Quispamsis, on the outskirts ...
Andrew MacLeod is a territory sales manager with Leviton Manufacturing of Canada in British ...
  Floyd Lau founded Amptek Technologies in 2002 as an end to end engineering design ...
Mike Marsh, President and CEO of SaskPower, has been a leading figure in Saskatchewan’s ...
Gordon MacDonald is a cheerful, driven individual who loves to be challenged, a trait that suits ...

Copper $US Dollar price per pound


 

Jean-Marc Myette

By Line Goyette

Meeting people in our industry often comes with surprises. This was the case with Jean-Marc Myette, Business Development Manager of ABB’s Electrification Products Division and chair of the Board of Electro-Federation Canada’s Quebec section. Not only does he know the electrical industry down to the most minute product and technological innovations, he is also a professional car racer on sabbatical, and someone very involved in his business community and personal life.

Read More

 

 

Kerrwil Publications

538 Elizabeth Street, Midland,Ontario, Canada L4R2A3 +1 705 527 7666
©2018 All rights reserved

Use of this Site constitutes acceptance of our Privacy Policy (effective 1.1.2016)
The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of Kerrwil