Interim Order Regulating UV Radiation-Emitting and Ozone-Generating Devices Under the Pest Control Products Act: Overview

EIN Can logo 400

September 7, 2021

Issue

More ultraviolet (UV) radiation-emitting and ozone-generating devices such as lights and wands have become available for sale in Canada since the COVID-19 pandemic. Some of these devices are marketed to kill bacteria and viruses, including SARS-CoV-2, the virus that causes COVID-19.

The devices are sold for use:

On many surfaces and objects in the home, including:

  • keys
  • cell phones
  • remote controls
  • in water, such as humidifiers
  • in the air in small- to large-sized rooms

Devices that claim to reduce or kill viruses must be registered or authorized to ensure they meet Canadian health and environmental standards.

Health Canada has not received enough evidence to confirm that these devices are safe for users and the public or that they are effective. These devices have not been evaluated against the requirements of the Pest Control Products Act (PCPA). They may, therefore, pose a serious health and safety risk.

The risk is that Canadians may rely on unsafe and unproven products in the belief that they are protecting themselves from COVID-19. This false sense of security may result in people not following proper disinfection procedures. Thus, they may, be accidentally putting themselves at risk.

For example:

  • exposure to UV light from UV radiation-emitting devices may cause serious injuries, including severe burns to the skin and eyes
  • inhaling ozone from ozone-generating devices may impair lung function, irritate respiratory pathways, inflame pulmonary tissues or cause irreversible lung damage

If you have a UV radiation-emitting wand that claims to prevent COVID-19 or claims to kill bacteria or viruses on surfaces or objects, stop using it immediately, especially if it is for use on the skin. Health Canada’s advisory warns Canadians about the risks of using UV lights and wands that make unproven claims to kill SARS-CoV-2.

Consult a health care professional if you have used these devices on the skin and have any concerns.

UV radiation-emitting or ozone-generating devices should not be used as a substitute for infection prevention measures, such as:

  • frequent hand washing
  • physical distancing
  • mask-wearing
  • cleaning and disinfecting

The Government of Canada has published a list of hard-surface disinfectants and hand sanitizers that meet Health Canada’s requirements.

Purpose of the interim order

The Interim Order to regulate certain ultraviolet radiation-emitting devices and ozone-generating devices under the Pest Control Products Act came into effect on June 7, 2021. Its purpose is to address the serious health and safety concerns of UV radiation-emitting or ozone-generating devices marketed in Canada, mainly for use in domestic dwellings.

This interim order (IO) clarifies that certain UV radiation-emitting and ozone-generating devices are subject to the Pest Control Products Act (PCPA) and its Regulations. The devices subject to the IO claim to control, destroy, make inactive or reduce the level of bacteria, viruses, and other micro-organisms that cause diseases in humans.

Specifically:

  • UV radiation-emitting devices where the UV lamp is fully shielded or enclosed in the device to prevent exposure to UV radiation may be authorized to be sold or used without being registered if they meet certain requirements.
  • Certain other UV radiation-emitting devices and ozone-generating devices must be registered by Health Canada’s Pest Management Regulatory Agency (PMRA) before they are allowed to be sold or used in Canada.

All such devices must meet labeling requirements. Product label information is intended to clearly instruct users on how to use pest control products safely and in such a way as to avoid risk.

About the Pest Control Products Act

Health Canada’s PMRA is the regulatory authority in Canada responsible for regulating pesticides (pest control products) under the authority of the PCPA and its Regulations. Pest control products must be registered by the PMRA, or otherwise authorized under the PCPA, to ensure they meet Canadian health and environmental standards.
The PMRA’s primary mandate is to:

  • protect the health of Canadians and the environment
  • ensure that the products in the marketplace are safe and effective

The PMRA does this by regulating products used to control pests, which can include bacteria, viruses, fungi, and mold.
All pest control products manufactured, imported, distributed, or used in Canada:

  • must be registered or otherwise authorized by the PMRA under the authority of the PCPA before they can be imported, sold, or used in Canada
  • are subject to rigorous science-based assessments by Health Canada scientists before being approved for use in Canada
  • are re-evaluated on a cyclical basis to make sure they continue to meet current health and environmental safety standards and continue to have value
  • must bear the Canadian label and be used according to label directions

Unregistered or unauthorized devices are prohibited and may be subject to compliance and enforcement action.

All UV radiation-emitting or ozone-generating devices registered by Health Canada are listed in the Pesticide Product Information Database. To confirm if a particular UV radiation-emitting device meets the conditions to be authorized without the need for registration, consult the manufacturer of the device. You should not use the device until you can confirm that it is compliant with the PCPA.

Related regulatory authorities

Whether they are classified as pest control products, medical devices, or consumer products, all products that emit UV radiation are governed by the Radiation Emitting Devices Act (REDA). The REDA governs the radiation safety of devices that emit electromagnetic or acoustical radiation, including UV radiation. While the types of UV radiation-emitting devices that would be subject to this IO do not fall into any of the prescribed device classes under the Radiation Emitting Devices Regulations, the general requirements of REDA apply to all products that emit UV radiation.

For more information about REDA requirements, contact the Consumer and Clinical Radiation Protection Bureau by email at hc.ccrpb-pcrpcc.sc@canada.ca.

To replace a lamp (for example, mercury vapor or light-emitting diodes (LEDs)) contained in a UV device, follow the instructions in the device’s operating manual. Dispose of or recycle the lamp according to local applicable laws.

Source

Related Articles


Latest Articles

  • Lever Connectors and Twist-Ons: How to Decide Which is Right for the Job

    Lever Connectors and Twist-Ons: How to Decide Which is Right for the Job

    There are many different types of wire connectors, and sometimes it can be hard for electricians to determine which one is best to use. Read More…

  • Winnipeg Information Bulletin: Low-Risk Voice, Data, Video & Security System Installations

    Winnipeg Information Bulletin: Low-Risk Voice, Data, Video & Security System Installations

    September 17, 2026 Certain types of installations may qualify for a low-risk voice, data, video (VDV) and security system electrical permit. For information related to regular VDV/security system installations, see winnipeg.ca/vdvsystems. Applications must be submitted through Permits Online. Electrical permits and inspections are needed for certain installations of security and similar alarm systems. This makes… Read More…

  • What Type of Outdoor Light Do I Need for My Application?

    What Type of Outdoor Light Do I Need for My Application?

    September 17, 2026 By Stanpro The right outdoor light starts with the space you need to illuminate and how that space is used. For commercial projects, parking lots and large exterior areas point toward area lights; entrances and building perimeters toward wall-mounted or security lighting; signs, facades and targeted areas toward flood lights; pathways toward… Read More…

  • Alberta Employers and Tradespeople Share their Perspectives

    Alberta Employers and Tradespeople Share their Perspectives

    September 16, 2026 In Alberta’s skilled trades labour market employers and tradespeople are facing growing pressure from tariffs, rising costs, hiring challenges and labour mobility barriers. CAF-FCA’s new report, Hiring, Mobility and Needed Supports: Alberta Employers and Tradespeople Share Their Perspectives, takes a closer look at what’s happening on the ground. Based on surveys of… Read More…


Changing Scene

  • MacKinnon Magnetics Partners with Adanac Sales in BC and Yukon

    MacKinnon Magnetics Partners with Adanac Sales in BC and Yukon

    October 5, 2026 MacKinnon Magnetics is excited to welcome Adanac Sales LLP as their new sales agency partner representing British Columbia and Yukon! The Adanac team brings industry expertise, strong local relationships, and a commitment to supporting customers – qualities that make Mackinnon Magnetics excited about what they can build together. “This partnership marks another… Read More…

  • Government of Canada Introduces Legislation to Transform how Canada Builds

    Government of Canada Introduces Legislation to Transform how Canada Builds

    October 2, 2026 The world is changing rapidly. In response, Canada is focused on what we can control: building a stronger, more independent, and more sustainable economy. We are leveraging our strengths and moving with speed to open new markets, strengthen supply chains, accelerate projects, and unlock our natural resources. As we build, we are… Read More…

  • Ontario Awards Construction Contract for New Little Current Swing Bridge

    Ontario Awards Construction Contract for New Little Current Swing Bridge

    October 2, 2026 The Ontario government has named a construction manager for the Little Current Swing Bridge replacement project. The new bridge will replace the existing bridge on Highway 6 connecting Manitoulin Island to the mainland, providing reliable, year-round access to the provincial highway network and making it easier for workers and families to connect… Read More…

  • Construction Starting on new Pitt Meadows Secondary School in BC

    Construction Starting on new Pitt Meadows Secondary School in BC

    October 2, 2026 Construction is beginning on the new Pitt Meadows Secondary school, which will provide students with a safer and more modern environment to learn. “Pitt Meadows is a vibrant community with a bright future and I’m proud that the local high school will soon better reflect the community it serves,” said Lisa Beare,… Read More…