Lighting Cited as Contributor to Global Prosperity

Lighting Prosperity

Societies have “huge potential” to boost economic performance and generate significant environmental and social benefits by improving energy, asserts The 2015 Energy Productivity and Economic Prosperity Index. Europe alone could double its energy productivity performance on the basis of existing technologies. Key contributors identified by the report include energy efficient lighting, insulation, appliances, and heat pumps.

The report, a briefing document for policy makers, notes that applying a “high energy-productivity growth scenario” would improveour lifestyle by freeing up more money for spending on health, recreation and education. However, the report warns that we’re deploying new technology tooslowly to keep up with rising energy demand. While the current rate of energy productivity improvement is pegged at 1.3% each year, the InternationalEnergy Agency (IEA) assumes the globaleconomy will continue growing at 3.6% per year.

The report was produced by the Lisbon Council for Economic Competitiveness and Social Renewal, a Brussels-based think tank and policy network, in collaboration with Ecofys, an energy and environment research agency, and Quintel Intelligence, an energy modelling firm.The three organizations created the index to gauge the efficiency andeffectiveness with which energy resources arebeing used worldwide. “Simply put, societiescannot change what they can’t measure.And while we know a lot about how muchenergy the world consumes annually (560exajoules in 2012), we are not very good atmonitoring our progress in the vital area ofenergy productivity where so much futurewellbeing will be determined.”

How lighting fits in

Recent lighting trends “amount to a veritable revolution in what is possible – and affordable,” says the report. The high-energy productivity growth scenario it developed for this policy brief estimates that with better lighting nearly 12 European households could be lit with a 1000 kWh of electricity – roughly what it takes to light two households today.

The report attributes this lighting revolution in part to government policy and industry’s response. “In the early 2000s, LED lighting entered the consumer market. As the new lights were expensive, they did not gain market share fast. This changed when several developed countries and regions (including the European Union) proposed a phase out of incandescent lamps in 2009 in an effort to encourage and enforce the transition to this vastly more energy efficient form of lighting. Since then, the cost of LED lights has decreased 85%, making them an affordable choice in houses, offices and public spaces. Current LED bulbs are up to seven times more efficient than incandescent bulbs while lasting about 25 times longer. The result is a dramatic acceleration in the amount of energy that can be saved through better lighting. 

How nations compare on energy productivity

The 2015 Energy Productivity and Economic Prosperity Indexis the first global report to rank countries by their energy productivity – based on their economic output per unit of energy consumed. At the top of the list: Hong Kong. The report attributes part of Hong Kong’s success to “having outsourced large swathes of its manufacturingto Guangdong province, just across PearlRiver delta.”

Perhaps more telling is the country ranked second: Cuba. “WhileCuba remains well behind the rest of theworld in industry, exports and overall levelof development, it has become a world leaderin energy productivity, weighing in at ashow stopping €365 billion of gross domesticproduct per exajoule of energy consumed, thebest energy performance in the world.” The report attributes this to economic necessity: “After the collapse of the SovietUnion, the island state had to restructure itseconomy drastically to learn to live withoutthe cheap energy the USSR had until thenroutinely provided (in 2005, it became thefirst nation in the world to ban the sale andimport of incandescent light bulbs).”

Canada, you ask? We sit in 44th place.

Lisbon Lighting Table

 

Key findings

Here are seven conclusions drawn from the report.

1. All regions of the world could improve their energy-productivity performance dramatically based on more aggressive adoption of existing technology. “For the developed world, we believe Europe alone could see an economic expansion of 35% by 2030 and cut its energy use to 30.1 exajoules per year, a 35% improvement on current levels even while the economy grows at a healthier pace. For the developing world, there is a chance to “leapfrog” the developed world and move speedily towards cost saving energy-productivity levels.” 

2. Most of the improvements will have to come from better energy performance in residential and non-residential buildings, which could bring in annualenergy savings of around 4%, respectively, between now and 2030.Industry would have only save roughly 1% per year to help society double overall efficiency. “Improvements on this size and scale are within the realm of possibility based onbroader deployment of technology that exists today,” says the report.

3. Given the role of building refurbishment in delivering broad gains, the key technologies will be insulation, energy-efficient appliances and lighting, and state-of-the-art heat pumps, which would consume more electricity to operate but do more to improve overall energy efficiency in most buildings. The average household could improve energy productivity by 500% just through lighting available today.

4. Regulators must be prepared to deploy an arsenal of tools, including mandating high energy-efficiency standards in automobiles, lightbulbs, household appliances, refrigerators, and especially buildings. Improved labelling also helps by providing transparency on the energy choices consumers face when they make purchases. 

5. Policymakers should be prepared to set ambitious targets, use their power of persuasion and promote the benefits of transition on a consistent basis. 

6. Progress will be most important in the world’s six largest economies: the European Union, the U.S., China, India, the Russian Federation,and Japan. Collectively, these six economies account for 60% of global GDP and 65% ofglobal energy demand.

7. The IEA estimates that doubling energy productivity gains by 2030 would create at least 1.1% of additional GDP in the European Union.The global fossil fuel bill could be reduced by more than €2 trillion (compared to abusiness-as-usual scenario). Moreover, this would create more than six million jobs globally by 2020, net of any job losses in low energy-intensity sectors. Improving energy productivity is also a key measure to realize the greenhouse gas emissions reductions needed to keep the global temperature increase within a maximum of two degrees centigrade, the globally agreed target.

Read the full report: http://www.lisboncouncil.net/publication/publication/121-the-2015-energy-productivity-and-economic-prosperity-index.html.

 

Related Articles


Latest Articles

  • Stephanie Medeiros on EV Infrastructure in Canada, Innovative Technologies, Well-Planned Charging Networks, & Commercial Fleets

    Stephanie Medeiros on EV Infrastructure in Canada, Innovative Technologies, Well-Planned Charging Networks, & Commercial Fleets

    September 3, 2026 By Blake Marchand In this Q&A with Stephanie Medeiros, the Head of Mobility at Schneider Electric Canada provides insight into her perspective on EV charging infrastructure in Canada, factors that will contribute to growing EV adoption, grid modernization for commercial fleets, the role of Vehicle-to-Grid and other innovative approaches to electrification. The focus of… Read More…

  • LEDVANCE: Understanding Light Beam Angles

    LEDVANCE: Understanding Light Beam Angles

    September 3, 2026 Light Beam Angles: How It Affects Different Types of Lighting, Where It Is Applied & What to Consider When Choosing the Right One Beam angle is important in lighting design. It determines how light spreads within a space and influences both functionality and atmosphere. By understanding beam angles, you can achieve both… Read More…

  • ITC 101 Series: Why Certifications (UL, CSA) Matter in Industrial Components

    ITC 101 Series: Why Certifications (UL, CSA) Matter in Industrial Components

    September 2, 2026 By ITC Electrical Components When selecting industrial electrical components, certification is more than a logo on a datasheet. A certification mark indicates that a product or component has been independently evaluated against specified requirements for its intended market. In North America, selecting products with the appropriate certification can affect regulatory acceptance, equipment… Read More…

  • Project Spotlight: Leigh Square Fountain

    Project Spotlight: Leigh Square Fountain

    September 2, 2026 In spring 2025, the City of Port Coquitlam unveiled a transformed Leigh Square, reimagined as a vibrant, accessible, and welcoming gathering place in the heart of downtown. At the heart of the renewed plaza, a Bellagio-style programmable dancing fountain is integrated directly into the paving—three interlocking rings where jets rise, fall, and… Read More…


Changing Scene

  • 2026 Ontario Apprenticeship Awards Call for Nominations

    2026 Ontario Apprenticeship Awards Call for Nominations

    September 3, 2026 Skilled Trades Ontario is proud to open nominations for the 2026 Ontario Apprenticeship Awards, recognizing outstanding apprentices, journeypersons, organizations and skilled trades leaders who are helping strengthen Ontario’s apprenticeship system. Award recipients will be announced at the Ontario Apprenticeship Summit on November 4, 2026, at the Toronto Congress Centre. Nominations must be submitted… Read More…

  • Bartle & Gibson Announces New Partnership with Hubbell Canada

    Bartle & Gibson Announces New Partnership with Hubbell Canada

    September 3, 2026 Bartle & Gibson Co. Ltd., an Alberta-based premier plumbing, heating and electrical distributor and Hubbell Canada have announced a new regional partnership enabling increased access to Hubbell Canada’s end-to-end electrical product portfolio across Western Canada. “With our strong presence in the west through 31 branches and counting located in Alberta, Saskatchewan, British… Read More…

  • Bartle & Gibson Opens Salmon Arm Location

    Bartle & Gibson Opens Salmon Arm Location

    September 3, 2026 Bartle & Gibson opened their new Salmon Arm location on July 20th. The Salmon Arm location features: This site is strategically positioned in the city of Salmon Arm, located near to the busy Picadilly Mall.  Salmon Arm branch is located at: 621- 10 Street SW Salmon ARM, BC V1E 1T1 Photo Source Read More…

  • MacKinnon Magnetics Announces Partnership with Resilient Sales Corporation in Northeastern Ontario

    MacKinnon Magnetics Announces Partnership with Resilient Sales Corporation in Northeastern Ontario

    September 3, 2026 MacKinnon Magnetics is pleased to welcome Resilient Sales Corporation as their newest sales agency partner. Resilient Sales will represent MacKinnon Magnetics across Northeastern Ontario, including the Districts of Muskoka and Parry Sound. Key markets include Sudbury, North Bay, Timmins, Kirkland Lake, Sault Ste. Marie, Huntsville, Bracebridge and Parry Sound. “This partnership expands… Read More…